AP0263510, AP0263530, AP0263540 5 GHz SU/Alpha Assembly Boards REFERENCE GUIDE
Regulatory Compliance FCC/ISED - Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ISED RSS standards. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Prudence Warning Avertissement Les unités extérieures et les antennes doivent être installés que par des professionnels expérimentés d'installation qui sont familiers avec les normes locales et les codes de sécurité et, si applicable, sont agréées par les autorités gouvernementales de réglementation compétents. Ne pas le faire peut annuler la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services d'obligations juridiques et financiers.
Overview The AP0263510, AP0263530, AP0263540 is a 5 GHz assembly board operating in the 5.2, 5.3, 5.4 and 5.8 GHz frequency bands. It is a TDD OFDM radio supporting 10, 20 MHz, 40 MHz and 80 MHz channel bandwidths. It is a 2x2 MIMO transceiver. The assembly board contains the power supply block, the CPU and peripheral block, the Ethernet communication interface and the radio transceiver block on a single board. It is installed in a host enclosure manufactured by RADWIN.
Antennas The AP0263510, AP0263530, AP0263540 5 GHz assembly board is certified with a wide range of antenna types covering both Point-to-Point and Multipoint systems up to 32 dBi gain.
5250 – 5350 MHz band – FCC Part 15 Subpart E, RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. The power values are for systems with 13 dBi antenna gain not exceeding the 30 dBm EIRP limit 20 MHz: 17.0 dBm 40 MHz: 17.0 dBm 80 MHz: 17.0 dBm 5470 – 5725 MHz band – FCC Part 15 Subpart E, RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. The power values are for systems with 13 dBi antenna gain not exceeding the 30 dBm EIRP limit 20 MHz: 17.
