Installation Guide

FinMInstallationGuide Release4.5.25 2‐6
TBSMounting SiteInstallation
TBSMountingonaVerticalPole
Allsizes
1. Fastenthestandoffstothebaseplateintheholeslabeled“V”asshown:
Figure2‐5:Fastenstandoffstobaseplate(forverticalpole)
2. PlacetheTBSasshownoverthestandoffs,andusingtheAllenscrewsandwashers,fasten
theTBStothebaseplate.
 
Figure2‐6:FastenTBStobaseplate(forverticalpole)
VerticalPole‐thin
1. Diameter3/4to11/2:BeforeraisingtheTBSonthepole,positionthepoleclampasshown
inthefollowingtwofigures.Donotcompletelytightenthebolts: