Installation Guide

Table Of Contents

FinMInstallationGuide DQ0266070/A.01 2‐13

TBSMounting SiteInstallation

2. PlacethisassemblyonthepolewhereyouwanttomounttheTBS.Onceitisinplace,

rotatethepoleclampasshown,thentightenbothbolts.

HoriztonalPole‐thick

1. Diameterlargerthan3:Usemetalbands(notsupplied),threadedthroughtheholesas

showninFigure 2‐28,orU‐bolts(notsupplied),fastenedusingtheholesasshownin

Figure 2‐29:

TBSmountingonawall

1. Fastenthestandoffstothebaseplateintheholeslabeled“V”or“H”,whicheverismore

convenient,asshown:

Figure2‐26:Mediumpole:Rotateclamp Figure2‐27:Mediumpole:tightenbolts

Figure2‐28:UsingmetalbandsforalargepoleFigure2‐29:UsingU‐boltsforalargepole

FOR REGULATORY REVIEW