Installation Guide
Table Of Contents
- Installation Guide
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Installation Steps
- 2.1 Prepare Laptop
- 2.2 Connect Laptop to Radio Unit
- 2.3 Update Connectivity Parameters of Radio Unit
- 2.4 Check items to be installed
- 2.5 Prepare Tools
- 2.6 Mount the HBS
- 2.7 Connect HBS antenna
- 2.8 Install SU Mounting Kit
- 2.9 Mounting the SU
- 2.10 Ground Radio Unit
- 2.11 Mounting the Lightning Protection Units
- 2.12 Waterproofing
- 2.13 Connect Radio (External Connections)
- 2.14 Check Connectivity to Radio
- 2.15 Request (and receive) permitted frequencies
- 2.16 Activate HBS
- 2.17 Align SU Unit
- Chapter 3: Safety Practices and Provisions
- Appendix A: Wiring Specifications
- Appendix B: About Antennas
- Appendix C: Terminology
- Appendix D: Certified Antennas
- RADWIN Worldwide Offices
TVWhiteSpaceInstallationGuide Release1.0 2 ‐19
SUUnits InstallationSteps
2.13.2SUUnits
Figure2‐27:Inputport:SUunit
2. Addsealanttapetotheconnections(see"Waterproofing"onpage2‐17.)
3. RoutetheCAT‐5eandgroundcablesdownfromtheradiotoaPoEvia2LPUs:one
neartheradio,onenearthePoE.FastenCAT‐5ecableconnectionswithacable
gland,addse
alanttape.
4. Connectgroundcabletoground.
5. PerformfinalconnectionsviaaPoE,dependingonthetypeofPoEyouareusing,
asfollows:
IndoorPoE
a. ConnectCAT‐5ecablefromlowerLPUto“Out”port
b. ConnectLANcableto“In”port.
c. Connectpowercable
2.14CheckConnectivitytoRadio
1. Connecttoradiounit:
• Fromalaptopinthefield:DisconnectthePoEfromthecommunicationsnetwork
(LANconnection),andconnectthelaptop.
FOR REGULATORY USES ONLY