User manual

• Simultaneously, the workspace of the display indicates a message:
<Start estimating density>.
28.2. Local setting of a working mode
Local settings for the working mode <
Density> are accessible on
pressing a hot key <
Local parameters>:
Standard liquid
Function dedicated for determining the standard liquid.
There are three options: water, alcohol and other. If option
“other” is selected, then its density should be specified. In
case of the other two types of liquids, their ensity values
are implemented in the software
Temperature
Parameter of the standard liquid inserted by the scale
user. Declared temperature of the standard liquid
automatically determines its density based on a table of
liquid densities. In case of the liquid type “Other”, the
temperature parameter is not applicable, the density value
is inserted manually
Standard liquid
density
Parameter designed for manual determining the density of
standard liquid in [g/cm
3
]
Sinker volume
Parameter implemented for manual determining the
volume of a sinker expressed [cm
3
]
Ask about sample
number
Function ordering inserting number of a sample before
initaining the test procedure
Pycnometer mass
Parameter designed for manual determining mass of a
pycnometer expressed in [g]. If inserted value is equal to
„0” then on test procedure start, the pycnometer mass
shall be measured.
Pycnometer density
Parameter intended for manual determining volume of the
pycnometer expressed in [cm
3
]
Unit
Weighing unit set to read the measurement result. This
weighing unit is used for presenting measurement result,
data in reports, databases and summaries.
Save mode
Detailed description in ch. 23.1 of the user manual
Checkweighing
Detailed description in ch. 23.3 of the user manual
Tare mode
Detailed description in ch. 23.4 of the user manual
Statistics
Detailed description in ch. 23.6 of the user manual
100