User manual

• Choose „ Counting pieces / Minimum reference mass”

and then set an appropriate value.

Accessible settings: 1 d, 2 d, 5 d, 10 d.

Notice:

While the procedure of evaluation the mass of single piece the the mass

of all pieces put on the pan is lower than the value declared in parameter

„

Minimum reference mass”, the following warning message will

be displayed: < Too low sample mass>.

22.9. Selecting the series type

It concerns the < Comparator> working mode

Procedure:

• Enter group of parameters < Working modes> according

to ch. 22 of this manual: „

Comparator / Method”

and then choose the right method.

Accessible methods:

• ABBA

• ABA

22.10. Declaration of the number of measurement series

It concerns the < Comparator> working mode

Procedure:

• Enter group of parameters <

Working modes> according

to ch. 22 of this manual,

• Choose: „

Comparator / Number of measurements”

then an editing field will appeare < Number of measurements>

with the screen keyboard,

• Inscribe the required value and confirm it by pressing