User manual

In order to enter < Communication>, press and then:

„ Parameters / Communication”.

15.1. RS 232 settings

Procedure:

• Enter < Communication> according to ch.15 of the manual, select

COM1> or < COM2>, and then set an appropriate value.

For RS 232 following parameters are accessible:

• Baud Rate - 4800, 9600, 19200, 38400, 57600, 115200 bit/s

• Data bits - 5, 6, 7, 8

• Stop Bit - No, 1, 1.5, 2

• Parity - No – Odd – Even – Mark – Space

15.2. ETHERNET setting

Procedure:

• Enter < Communication> according to ch.15 of the manual,

select <

Ethernet> and then set an appropriate value.

Following settings are accessible for Ethernet:

• DHCP - Yes – No

• IP Address - 192.168.0.2

• Subnet Mask - 255.255.255.0

• Default gateway - 192.168.0.1

Notice:

The settings above are only for information purposes. Transmission

parameters should be matched to the local client network.

• After making changes press , then a new message is displayed:

<Restart to apply the changes>,