Instruction Manual

NONE
- Correction function disabled
CONSTAN
T
- Dosing refered to a constant nominal value of
correction
AUTO
- enabling automatic correction
Return to weighing:
See 11.3.
24.7.6.2. Initial correction value
In parameter <P7.4.6.2 START CORRECTION> a user can set a mass
value to be subtracted from or added to the nominal mass.
Procedure:
• Enter <P7 WORK MODES> and then:
• Use the scale keyboard a starting correction value and confirm it by
pressing
.
Notice:
1. The starting correction value is estimated experimentally in at least 2
subsequent cycles of dosing;
2. In correction mode <CONSTANT>, the start correction is always the
correction value, but in correction mode <AUTO> the declared start
value is used only in the first dosing cycle. Then it can be modified.
Return to weighing:
See 11.3.
- 110 -