Instruction Manual
Table Of Contents
- 1. INTENDED USE
- 2. PRECAUTIONS
- 3. WARRANTY CONDITIONS
- 4. MAIN DIMENSIONS
- 5. DESCRIPTON OF CONNECTORS
- 6. UNPACKING AND ASSEMBLY
- 7. GETTING STARTED
- 8. LOGGING ON
- 9. SCALE WINDOW DISPLAY
- 10. WEIGHING PROCEDURE
- 11. WINDOW NAVIGATION
- 12. PRODUCT CHOICE
- 13. CHOICE OF A CONTRACTOR
- 14. CHOOSING A PACKING
- 15. STORE CHOOSING
- 16. LOT CHOOSING
- 17. LOT 2 CHOOSING
- 18. QUANTITY NUMBER CHOOSING
- 19. DATABASES
- 20. COUNTING PIECES
- 21. TRANSACTIONS
- 22. STATISTICS
- 23. WEIGHING RECORDING
- 24. PROGRAMMABLE BUTTONS
- 25. LOGGING OFF
- 26. CHECKWEIGHING THRESHOLDS
- 27. PROGRAM’S OPTIONS
- 29. WEIGHING PARAMETRES SETTING
- 30. ERROR MESSAGES
- 31. LABEL DESIGNING
- 32. DIAGRAMS OF CONNECTION CABLES
- 33. CONNECTORS
- 34. SPECIFICATION OF ADDITIONAL MODULES
- 35. ADDITIONAL EQUIPMENT
- 36. TECHNICAL PARAMETERS
- 37. APPENDIX A – SETTING A BARCODE SCANNER
Switch settings SW1:
1 – ON
2 – ON
3 – OFF
7. Connect socket SUB-D with a cable,
8. Remove the hole plug from one of the free glands and led the cable
through;
9. The cable connect to the group of wires (unhook band clips
fastening the group of wires, lay the cable and hook the band clips).
Band clips of multiple usage;
10. Screw down the back wall.
11. Set in the MS Windows Device manager, USB serial port on COM4
35. ADDITIONAL EQUIPMENT
Additional weighing platform module - Metrological parameters
as for main platform
In / out module - Additional 8 in / out
Profibus DP V1 interface - Slave working mode
- 132 -