Instruction Manual

34. SPECIFICATION OF ADDITIONAL MODULES
Apart from standard interface, it is possible to equip terminals PUE 5
with additional module increasing functionality of devices:
• Weighing module MW-02
• 8 inputs / 8 outputs module WE 8,
• 4 inputs / 4 outputs module WE 4,
• Analogue output module of AN series,
• Interface Profibus DP V1.
34.1. Weighing module MW-02
The weighing module MW-02 is responsible for the whole process
of weighing. It is supplied with factory parameters and scale parameters
(filters, units, etc.) memory. It is installed in the main board of PUE 5. The
module is supplied with factory parameters access button. The button is
protected with a seal.
Factory parameters are protected and can be accessible only after pressing
the calibration switch on the module during powering up. The module is
totally covered by the shield together with the calibration switch and
soldering pads of load cell.
The calibration switch is accessible through the hole in the shield and can
be additionally sealed with an external sticker.
Weighing module MW-02
- 117 -