User manual

65
17.4. Bargraph
A bargraph is a typical visualisation procedure. It helps in quick weighing.
It requires less concentration to read if a weighing is between minimum
and maximum thresholds.
17.4.1. Bargraph type
To see the bargraph on the screen enable it in parameters.
Procedure:
• Enter submenu “ Display / Bargraph” in accordance with
point 17 of this user manual,
• Seelct option <
Bargraph type> and set desired bargraph type.
Accessible bargraphs:
• Quick weighing,
• None (Bargraph is not displayed),
• Signalling checkweighing ranges,
• Linear,
• Control *.
*) – Applies to the CPG mode only. In the CPG mode other bargraph types
are not accessible.
17.4.2. Bargraph “Quick weighing”
Setting of bargraph type “Quick weighing” are accessible in submenu
„
Display / Bargraph / Quick weighing”:
MIN, MAX thresholds working
mode
Stable – signalling of MIN, MAX thresholds is
previewed on exceeding LO threshold and
reaching stable measurment result;
Unstable – signalling of MIN, MAX thresholds
is previewed on exceeding LO threshold
OK threshold working mode
Stable – signalling of OK thresholds is
previewed on exceeding LO threshold and
reaching stable measurment result;
Unstable – signalling of OK thresholds is
previewed on exceeding LO threshold