User manual

15.2. ETHERNET setting

Procedure:

• Enter < Communication> according to ch.15 of the manual,

select <

Ethernet> and then set an appropriate value.

Following settings are accessible for Ethernet:

• DHCP - Yes – No

• IP Address - 192.168.0.2

• Subnet Mask - 255.255.255.0

• Default gateway - 192.168.0.1

• DNS - 192.168.0.1

• MAC Address - ---

Notice:

1. The above settings are presented for information purpose only.

Transmission parameters have to be selected in accordance with

client’s local network settings.

2. Parameter <MAC Address> is automatically assigned to a device

and it is has <Read only> Attribute.

3. In case of declaring the <DHCP> parameter to value and on device

restart, the other transmission parameters have <Read only> attribute.

• After making changes press key, then a new message is displayed:

<Restart to apply the changes>,

• Go back to weighing and restart the device.

15.3. TCP protocol setting

TCP (Transmission Control Protocol) is a protocol for communication

between two computers. It operates in mode client-server. Server awaits

on connection iniciation on a specified port while client initiates connection

to the server. Scale software allows setting the port for the „Tcp” protocol.