User manual

142
Notice:
A pattern and example of the report from estimating average tare are
described in ch. 30.14 of this manual.
30.10. Performing distructive testing in modes Empty-Full and
Full-Empty
“Destructive” control process complying with the resulation, and
independently on the batch size that exceeds 100 pcs., the size of a sample
accepted by the software for control process is 20 pcs. Other control criteria
are accepted as specified in the regulation.
After selecting from a list a product with set options for the destructive control
with determined measuring “lot”, and starting the control process, the
software will display messages facilitating the control process (as in the case
of control process described above).
Depending on the set control mode, the scale orders the following sequence
of weighing products: “empty-full” or “full-empty”.
Notice:
Remember to maintin the order for weighing products with packages and
empty packages. It is important to the software that carries out mass
calculations of products placed in a specific packaging.
After the test has been comleted the test is summarised (see ch. 30.8)
and the results are automatically saved in the database.
Notice:
A pattern and example of the report from estimating average tare are
described in ch. 30.14 of this manual.
30.11. Control in accordance with internal criteria
Select a product with correctly determined parameters for carrying out the
control in accordance with the internal criteria (see ch. 30.4 of this manual).
After entering to scale memory general parameters of the working mode (in
accordance with ch. 30.2 and ch. 30.3 of this manual), start control process
by pressing
key (control start) located in the bottom bar of the mode
settings window.