User manual

140
Notice:
In case the scale cooeprates with the computer software <
E2R System>
the message on process summary does not contain a option for printing a
report. The data on a control is automatically sent to the computer software
with possibility of printing the report from the computer level.
If the test result is that the number of errors T, according to the regulations,
requires expanding the sample. Operator is informed about it it the following
message box:
Press and then some descriptions and boundary criteria are changed.
After the test has been comleted the test is summarised and the results are
automatically saved in the database and the report can be printed on an
attached printer.
Notice:
A pattern and example of the report from testing products are described in ch.
30.14 of this manual. A pattern and example of the report from estimating
average tare are described in ch. 30.13 of this manual.
30.9. Performing non-distructive testing in mode Empty-Full
For mode „Non-destructive Empty-Full” a user sets the measurement
“charge” in the product data. According to the set „charge” a message
is shown that informs about putting empty packages first and then the
same packages after they have been filled up in the same sequence: