User manual

130
Quantity of disqualifying
samples [Qn – T]
Number of recorded negative errors -T in
a tested sample that disqualifies a control
Quantity of disqualifying
samples [Qn + T]
Number of recorded positive errors +T in
a tested sample that disqualifies a control
Average limit value
Mode for calculating the average limit value
(constant or automatic)
Average limit value [ - ]
Average limit value (negative) for a tested
sample (refers to averge limit value as a
“constant”)
Average limit value [ + ]
Average limit value (positive) for a tested
sample (refers to averge limit value as a
“constant”)
Factor value [- Wk]
Standard deviation multiplier for the average
limit value (negative) determined in the
automatic mode
Factor value [+ Wk]
Standard deviation multiplier for the average
limit value (postive) determined in the
automatic mode
30.5. Control start procedure
To start testing:
• An operator needs to be logged on with the authorization access level
high enough to perform testing.
Caution:
The logging on procedure is described in ch. 11. The procedure
of outlining the authorization level is described in ch. 19 of this manual.
• Select a product to be tested with correctly determined data for the
control process,
• Enter to scale memory general parameters on control mode (in
accordance with ch. 30.2 and 30.3 of the manual),
• Remove load fro mthe weighing pan,
• Press function hot-key (control start) located in the bottom bar
of the settings window, which opens an information window on entered
data: