User manual

- 18 -

8.2. Return to weighing mode

CAUTION

Changes introduced in balance memory will be saved on return to

weighing with procedure of saving changes.

Press ESC/TARE key for several times, until the display shows

command SAvE?.

When display indicates the above command for saving changes, press one

of below options:

 PRINT/ENTER – save changes

 or ESC/TARE – abandon introduced changes, and leave to

balance menu.

After pressing an appropriate key, balance goes back to weighing

mode.

9. WEIGHING

Before start of weighing process or in case of essential change of ambient

conditions at a workstation (e.g. ambient temperature change at a workstation more

than 3

C) the balance requires adjusting. The procedure of balance adjustment is

described further in this user manual.

• Before start of weighing procedure, it is recommended to load the balance’s

weighing pan a few times with mass close to balance max capacity,

• Check if unloaded balance indicates “precise zero” - and whether

measurement is stable -

, if not press ESC/TARE key;

• Press Units key to set a measuring unit:

[g], [kg], [ct], and also if enabled in factory menu [lb], [oz], [ozt], [dwt], [t],

[mom], [gn],

• place weighed object on balance’s weighing pan and read result only on

stabilization of measurement result,