User guide

Tailoring Your User Experience | 20
RADVISION | User Guide for SCOPIA XT5000 Series Version 3.0
Step 3 Select General under Call-Answer.
Figure 4-1 The call-answer settings
Step 4 Select the required option from the Automatic answer list:
• Yes always: this setting enables automatic answer to an incoming call. The system will not
prompt you to accept a call if the display shows the Home page.
• Never: this setting disables automatic answer to an incoming call. The system will always
prompt you to accept a call.
• Yes if not already in a call: this setting enables automatic answer only if the system is not in
a call. If the system is in a call, it displays a notification about another incoming call, allowing
you to accept it. When you accept an incoming call already being in a call, the embedded MCU
is activated.
Step 5 (Optional) Enter the number of rings in the After Num. Rings list to specify after how many rings
the system accepts a call. This option is relevant only if automatic answering is enabled.
Step 6 Select Save.
Enabling Call Disconnection Confirmation
You can configure the system to request a confirmation when a call is disconnected.
Procedure
Step 1 Access the SCOPIA XT Series web interface.
Step 2 Select the User Settings tab.