User guide

Getting Started | 13
RADVISION | User Guide for SCOPIA XT5000 Series Version 3.0
Configuring Gatekeeper Settings
If your SCOPIA XT Series works in conjunction with a gatekeeper, configure gatekeeper-related
settings. Use this section to configure gatekeeper settings.
This procedure completes the basic system configuration.
Before You Begin
This procedure is performed as part of the basic configuration after “Configuring Network
Settings” on page 12.
Procedure
Step 1 Set the Enabled list to Yes.
Figure 3-6 XT Codec Unit
Step 2
Set the Mode list to Manual.
Step 3 Enter the IP address of the gatekeeper in the IP address field.
Step 4 Enter the H.323 number required to dial the XT Codec Unit in the Number H.323 field.
Step 5 Select Done.
The basic configuration of your SCOPIA XT Series is complete.