Setup guide

RADVISION, an Avaya Company | Release Notes
SCOPIA XT4000 and XT5000 Series | 7
SCOPIA XT5000/XT4000 Series - Version 3.1.0.28
This section of the release note describes the new features and capabilities included in the SCOPIA
XT5000/XT4000 Series software version 3.1.0.28 since previous version 3.0.132.
Please note that upgrading to version 3.1.0 requires a new license key.
Warning:
After loading this version over an earlier version, the completion of the upgrade
procedure may require up to two upgrade phases and two corresponding
automatic re-boots. A 30-40 seconds interval may occur between seeing the
initial graphical menu and the start of next upgrade phase.
System led may repeatedly blink during these phases.
Please, do not turn off the system until the upgrade procedure is completed.
This procedure is completed when you see the initial graphical menu still for at
least one minute.
Note:
Software upgrade packages named “XT5000_Vx_y_z.exe” can be used to upgrade
both XT5000 Series and XT4000 Series Codec Units.
What’s New
Version 3.1.0.28 introduces many new features, and some improvements and fixings. Following
sections briefly explains the main ones.
Embedded MCU and SCOPIA XT Desktop
This version supports embedded MCU4 (basic MCU) and MCU9 (site extension).
Embedded MCU can support 1080p30 on both live and presentation
For SMB deployment, XT Desktop is also supported (required XTD v7.7.200.37 or higher. See Note for
minimal XTD server reuirements).
Customers who own XT5000 CPU version 1.0 or version 1.1 and would like to upgrade to an internal
MCU should contact RADVISION for a product RMA.
Note:
To check your CPU version, browse to WEB Diagnostics>Software Version.
CPU version 2.0 or higher is required to enable MCU feature.
Note:
The following limitations apply to this first version of MCU for XT5000.
- Contribution of a single remote participant in the continuous presence
mosaic is up to 448p
- High Profile and SVC are supported only in pt-to-pt call, not during multi-
conference