Setup guide

RADVISION, an Avaya Company | Release Notes
SCOPIA XT4000 and XT5000 Series | 23
Category ID Description Resolution
JIRA#32420
IPOFFICE: embedded 5000:
Conference is put on hold when one
participant press hold.
JIRA#31460
IPOFFICE: IPO users are not able to
see the video images of other
conference participants if on the
Radvision sip trunk Direct media is
selected
In a Call
QC#9510
It’s not possible to redial an ISDN
Incoming Call Number through the
Recent Calls List
(Incident #156601)
QC#9509
There is not an immediate way to
dial out ISDN Voice Only Calls
(Incident #156599)
To dial out ISDN Voice Only Calls the following
procedure currently applies:
1. Change to “Manual” the “Service mode”
from WEB Administrator Settings -> Calls ->
Preferences -> ISDN
2. Insert a different Service Code for the 64K
Calls
3. Add/Define the same Service code to the
Gateway Service Prefixes List specifying that
its type is a “Voice Only” one
4. Dial out to the required ISDN/PSTN Phone
Number selecting 64K as the required Call
Rate (Advanced call options)
In a meeting
With multiple monitor scenario,
when presentation is not available,
the PIP on graphical monitor cannot
be forced
QC#18084
Embedded MCU "Make Lecturer"
feature is disabled
QC#18673
There is no possibility to add H.263
participants while in a conference
QC#18764
The SIP Endpoints joining a meeting
will not be able to send/receive any
presentation since SIP BFCP is not
yet supported by the embedded
MCU feature
QC#18675
During an embedded meeting, the
local video input cannot be
changed.
Software Upgrade
QC#18364
If the updating is done on system
equipped with PIC firmware rev 33
(implemented up to sw release
V3.1.019), sometimes it can happen
that at start-up the system keeps
rebooting with 3 or 5 led/logo
blinks as error code.
When it happens, plug/unplug the power jack
connector (the remote control power Off/On
command isn’t detected by PIC).
Network
QC#14601
QC#18670
XT5000, XT4200 network
negotiation issues on both ports
when using some particular network
equipment (Incident #24576-10154)
Always configure in “Autosensing” both the XT
and the (Giga)Switch LAN Port.
You can also limit the auto negotiation mode to
100/Full or lower
QC#18671
When using a telnet connection to
60123 port, each command must be
followed by a double enter to be
executed