Installation guide
Step 3
In the web interface, select Save.
Note
From the endpoint, your changes are saved automatically.
Step 4
Access the IP address settings, as follows:
•
From the endpoint, select the back key
on the XT Remote Control Unit, and select
either GLAN 1 or GLAN 2.
•
From the web interface, select Addresses under GLAN 1 or GLAN 2.
Note
GLAN2 is available in selected models only.
Figure 5-33 Configuring IP addresses from the web interface
Step 5
Set the fields as described in Table 5-15 on page 84.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 83