Installation guide

You would not normally route the local microphone to a speaker. You can hear your own
voices in the room, so normally you would not need to route the microphones to speakers.
This will avoid feedback loops.
If you are showing a presentation on your computer and it includes sound, route the sound
of the computer to the analog input connector.
Procedure
Step 1
Access the audio output settings as follows:
From the endpoint interface, select Configure > Advanced > I/O connections > Audio -
Outputs > General.
From the web interface, select Administrator settings > I/O connections > Audio -
Outputs > General.
Figure 5-31 Defining the routing of the audio outputs from the web
interface
Step 2
Set the fields as required.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 80