Installation guide
•
From the endpoint interface, select Configure > Advanced > I/O Connections > Cameras
> DVI. Press to start data sharing.
•
From the web interface, select Administrator Settings > I/O Connections > Cameras >
DVI. Press to start data sharing.
Configuring the Echo Canceller
If your SCOPIA XT Series works with an external microphone system that does not contain echo
cancellation, perform this procedure to cancel echo.
Before you begin
Enable echo cancellation as described in “Configuring the Microphone Pod” on page 74.
Procedure
Step 1
Access the echo canceller settings as follows:
•
From the endpoint interface, select Configure > Advanced > I/O connections > Echo
Canceller.
•
From the web interface, select Administrator settings > I/O connections > Echo
Canceller.
Figure 5-30 Cancelling echo from the web interface
Step 2
Set the fields as required.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 78