Installation guide

Procedure
Step 1
Access the DVI settings as follows:
From the endpoint interface, select Configure > Advanced > I/O connections > Cameras
> DVI.
From the web interface, select Administrator settings > I/O connections > Cameras >
DVI.
Figure 5-25 Configuring the computer settings from the web interface
Step 2
Select Yes from the Enable list to enable the DVI input.
Step 3
In the web interface, select Save.
Note
In the endpoint, the changes are saved automatically.
Setting up the Monitor Display Modes
The monitor can be configured from the SCOPIA XT Series by setting its resolution, and
configuring the system to work with a single monitor or two monitors side-by-side.
Some monitors crop the edges of the image shown in their displays. If this is the case, you
need to adjust the way the image appears as described in this procedure.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 69