Installation guide
Step 2
Select Administrator Settings.
Step 3
Select System > Location > General on the left.
Step 4
Set settings as described in Table 5-7 on page 63.
Table 5-7 Configuring regional information
Field Name Description
System name Enter the name that will appear in the local endpoint GUI and in the
remote endpoint GUI (if connected).
Country Select the country in which the local system is located. Once the
country is selected, the other fields are populated automatically.
Language Select the language used in the GUI.
Audio coding Select the European or US coding.
Video frequency The video refresh frequency depends on the country, and may
assume the values of 50Hz or 60Hz. The user may select the video
frequency automatically or manually. If set to automatic, the system
assigns the value depending upon the selected country. In Japan, the
frequency depends on the country area (east or west); thus in Japan
the system administrator must select manually the correct value
related to the geographic location.
Step 5
Select Save.
Configuring the Screen Saver to Start Automatically
The screen saver helps to protect your monitor from burn-in without switching it off. This can
be useful in situations when you stop using your SCOPIA XT Series for a relatively short period
of time.
Procedure
Step 1
Access the screen saver settings as follows:
•
From the endpoint, select Configure > General.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 63