Installation guide

Procedure
Step 1
Set the Use Gatekeeper list to Yes.
Figure 5-20 Gatekeeper settings
Step 2
Set the Mode list to Manual.
Note
If the gatekeeper is configured to be automatically detected by endpoints, select
Automatic (depends on the type of gatekeeper). Consult the network administrator.
Step 3
Enter the IP address of the gatekeeper in the Gatekeeper IP address field.
Step 4
Enter the H.323 number required to dial the XT Codec Unit in the E.164 field.
Step 5
Select Done.
The basic configuration of your SCOPIA XT Series is complete.
Setting Basic System Information
There are a number of settings to ensure the system is working with the correct XT Remote
Control Unit, and that the correct local time and date is properly configured:
Setting Date and Time ..................................................................... page 61
Setting the Time Zone ..................................................................... page 62
Setting Regional Information.............................................................. page 62
Configuring the Screen Saver to Start Automatically.................................. page 63
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 60