Installation guide
Table 5-4 Configuring IP addresses
Field Name Description
IP address Enter the system static IP address here, used for accessing and
managing the system.
If the system retrieves its IP address automatically, this field
displays the IP address assigned to the system.
SubNet mask Enter the subnet mask associated with the IP address.
If the system retrieves its IP address automatically, this field
displays the subnet mask that has been assigned.
Gateway Enter the default gateway static IP address. The gateway is used to
route information between two subnets, for example, between the
headquarters and a partner site.
If the system gets its IP address automatically, this field displays the
gateway IP address assigned to the system.
DNS Enter the DNS server IP address. The DNS server in your network
resolves domain names in your network and translates them into IP
addresses.
If the system gets its IP address automatically, this field displays the
assigned DNS server IP address.
Step 3
Continue with one of the following:
•
To configure your gatekeeper's settings, select Next and continue with “Configuring
Gatekeeper Settings” on page 59.
•
To exit the quick setup wizard, select Close.
Configuring Gatekeeper Settings
Gatekeepers are used to manage and route endpoint-initiated calls and point-to-point calls
(H.323). If your SCOPIA XT Series works in conjunction with a gatekeeper, configure
gatekeeper-related settings as described in this procedure.
This procedure completes the basic system configuration.
Before you begin
This procedure is performed as part of the basic configuration after “Configuring Network
Settings” on page 57. Consult with your network administrator to configure these fields.
Start the Quick Setup Wizard by selecting Configure > Quick Setup from the Main menu.
Note
If you are modifying these settings after initial setup, navigate to Configure > Network >
H.323 from the Main menu.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 59