Installation guide
•
Configuring Network Settings............................................................. page 57
•
Configuring Gatekeeper Settings......................................................... page 59
The tasks appear in this section in the order they are presented in the quick setup wizard.
The quick setup wizard automatically appears when you turn the Quick SetupXT Codec Unit
on for the first time. If the quick setup wizard is not displayed automatically, select Configure
> Quick Setup from the Main Menu.
Setting the System Name and Language
You can select the name of your XT Codec Unit, to be displayed on the monitors participating
in the videoconference call (for example: Hong-Kong, or 9th-Floor-Room, or NY-Office).
You can also select the country in which the system is located and the language in which the
system menus are displayed.
Before you begin
Turn on the SCOPIA XT Series unit to start the quick setup wizard.
or
If the quick setup wizard is not displayed automatically, select Configure > Quick Setup from
the Main menu (Figure 5-15 on page 53).
Note
After initial setup, you can modify these settings by selecting Configure > General from the
Main menu.
Procedure
Step 1
Enter the name of the SCOPIA XT Series in the System Name field using the alphanumeric
keys of the XT Remote Control Unit (for more information, see “Using the XT Remote Control
Unit” on page 43).
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 54