Installation guide

Pairing an XT Remote Control Unit with a XT Codec Unit
Multiple XT Codec Units can be set up in the conference room and controlled with different XT
Remote Control Units.
Each XT Remote Control Unit is dedicated to one XT Codec Unit by pairing them. This is done
by configuring the same numeric code in your XT Remote Control Unit and the system
software.
An XT Remote Control Unit is configured with code 01 by default.
Before you begin
Decide what numeric code you want to use for your monitor and the XT Codec Unit. You can
choose any value between 1-99.
Procedure
Step 1
Access the general settings, as follows:
From the web interface, navigate to:
Basic Settings > General.
From the endpoint itself, access the Main menu and navigate to:
Configure > General.
Figure 5-8 Setting the XT Remote Control Unit Code
Step 2
Enter the numeric code in the Remote control code field. You can choose any value between
1-99.
Step 3
In the web interface, select Save.
Note
From the endpoint interface, it is saved automatically.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 45