Installation guide
Step 4
Select Login.
Configuring Remote Management on the SCOPIA XT Series
Remote management on your SCOPIA XT Series is enabled by default. You can configure the
SCOPIA XT Series so that it can be remotely managed from any computer in the network, or
from a specific computer only.
To remotely upgrade the SCOPIA XT Series, you must also enable remote downloads, as
described in “Configuring Remote Upgrade Settings” on page 40.
We strongly recommend that you change the default credentials first time you access the
SCOPIA XT Series remotely, described as part of the procedure below.
See Administrator Guide for the SCOPIA XT Series for information on maintenance tasks to
configure and manage your SCOPIA XT Series.
Before you begin
To configure the network, contact your network administrator.
Procedure
Step 1
Access the remote management settings, as follows:
•
From the SCOPIA XT Series web interface, select Administrator Settings > Utilities >
Remote Access > Web.
•
From the endpoint, select Configure > Advanced > Utilities > Remote Access > Web
from the Main menu.
Figure 5-2 Configuring remote management on SCOPIA XT Series
Step 2
Set the fields as described in Table 5-1 on page 39.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 38