Installation guide
Connecting SCOPIA XT Series
For operational information about connecting SCOPIA XT5000 Series, refer to the Quick Setup
Guide for SCOPIA XT5000 Series.
Connecting SCOPIA XT Series to Your Network
Your SCOPIA XT Series has two GLAN 10/100/1000 ports for connecting to the network.
You can use both ports for connecting to the private and public network, however we
recommend that you always connect the private network to the second GLAN port, whether
one router interfaces with the SCOPIA XT Series or multiple routers interface with the SCOPIA
XT Series (Figure 4-1 on page 24).
Figure 4-1 Connecting the XT Codec Unit to a private and a public network
Connecting a Computer
Use a computer to share a presentation or other PC content during a call. This procedure
describes how to connect computers that are equipped with a DVI-out or VGA-out connector.
The XT Codec Unit supports many DVI input resolutions, listed in Table 4-1 on page 25.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Setting up the SCOPIA XT Series | 24