Installation guide

Before beginning the installation of the system, you must read the safety regulations for a
safe use of the system, verify the conference room setup, and check that the product
corresponds to your order. The setup prerequisites are described in these sections:
Complying with Safety Regulations...................................................... page 20
Planning the Conference Room Setup................................................... page 20
Inspecting the Product..................................................................... page 22
Complying with Safety Regulations
For detailed safety information consult the SCOPIA XT Series Safety Instructions leaflet
enclosed in the delivery package.
Planning the Conference Room Setup
Set up the conference room to enjoy virtual meeting. RADVISION provides useful information
on conference room setup in http://blog.radvision.com/videooverenterprise/2010/05/11/ask-
the-expert-designing-your-conference-room/
SCOPIA XT Series can receive the Infra-Red (IR) command of the XT Remote Control Unit via:
The XT Codec Unit IR receiver
The IR receiver of the XT Premium Camera or XT Standard II Camera. In this case the XT
Remote Control Unit sends the command to the XT Codec Unit using the VISCA connection.
The position of the XT Codec Unit in the conference room is not important for receiving
the signal from the XT Remote Control Unit. But it is important to connect the main
camera correctly to the XT Codec Unit via the VISCA Cross cable.
Place the XT Codec Unit anywhere within 5 meter reach of the camera cables. Leave enough
space for air circulation and for connecting cables easily.
3
Prerequisites for Setting up the System
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Prerequisites for Setting up the System | 20