Installation guide

Figure 2-5 Configuring the TCP or UDP port range from the web interface
Step 2
Define how the XT Codec Unit assigns ports by selecting one of the following from Auto
detect:
No: The XT Codec Unit uses the range of dynamic ports indicated and allows you to
define the base port (default and recommended setting).
Yes: The XT Codec Unit assigns ports randomly, and you cannot define the base port.
Step 3
If you selected No in the Auto detect list, you can modify the TCP or UDP base port in the
Ports field.
Note
You can configure the base port to any value between 1024-65535. The number of
ports is calculated automatically by the system, depending on whether you have an
MCU license and its type.
Step 4
In the web interface, select Save.
Note
In the endpoint, your changes are saved automatically.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Planning the Topology of the SCOPIA XT Series Deployment | 19