Installation guide

Table 5-23 Configuring general call settings
Field Name Description
<auto> (Recommended) This is the default and setting. It indicates
that the system tries to choose the settings that best suit the
local situation.
Rate K (IP) Sets the maximum call rate that the system uses for all
incoming or outgoing calls.
Audio Coding (IP) Sets the preferred Audio Coding that the system tries to use
for all incoming or outgoing calls, if the remote system
supports the same Audio Coding.
Video Coding (IP) Sets the preferred Video Coding that the system tries to use
for all incoming or outgoing calls, if the remote system
supports the same Video Coding.
Rate K (ISDN) Sets the maximum call rate that the system uses for all
incoming or outgoing calls in ISDN connectivity.
DualVideoCoding (IP) Sets the resolution for H.264 content video.
Use manual DualVideo
bandwidth (IP)
If set to Yes allows to change bandwidth used for content and
live video (DualVideo/Live bandwidth).
DualVideo/Live bandwidth
(IP)
Sets more bandwidth on Live Video or Content.
Step 6
In the web interface, select Save.
Note
In the endpoint, your changes are saved automatically.
Step 7
Access the IP settings as follows:
From the web interface, select Administrator Settings > Calls > Preferences > IP.
From the endpoint interface, select Configure > Advanced > Calls > Preferences > IP.
Figure 5-45 Configuring the IP settings from the web interface
Step 8
Set the fields as described in Table 5-24 on page 103.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 102