Installation guide

Figure 5-43 Configuring the Priority setting from the web interface
Step 2
Set the Priority setting to the GLAN port that the preferred network uses. This field specifies
in which order the system places outgoing calls.
Step 3
In the web interface, select Save.
Note
In the endpoint, your changes are saved automatically.
Step 4
Access the call settings as follows:
•
From the web interface, select Administrator Settings > Calls > Preferences > General.
•
From the endpoint, select Configure > Advanced > Calls > Preferences > General.
Figure 5-44 Configuring general call settings
Step 5
Set the fields as described in Table 5-24 on page 103.
RADVISION | Installation Guide for SCOPIA XT5000 Series Version 3.1 Initial Configuration | 101