User guide

Figure 4-2 The call-answer settings

Step 4

et Confirm disconnection to Yes.

Step 5

Select Save.

Configuring the SCOPIA XT Series to Block Incoming Calls by Default

You can configure the SCOPIA XT Series to block all incoming calls by enabling the Use Do Not

Disturb (DND) feature if you do not want to answer incoming calls.

When the Do Not Disturb feature is enabled:

•

The system blocks notifications of incoming calls.

•

The icon appears in the system information area of the monitor display.

•

hen the remote terminal calls, the system informs it that the call is rejected. The

calling terminal is automatically disconnected.

You can also block incoming calls manually as described in “Blocking Incoming Calls” on page

45.

Even when the system is set to blocking incoming calls by default, you can temporarily disable

the DND feature by holding the Privacy key

on the XT Remote Control Unit.

rocedure

Step 1

Access the SCOPIA XT Series web interface.

Step 2

Select the User Settings tab.

Step 3

Select General under Call-Answer.

RADVISION | User Guide for SCOPIA XT4000 Series Version 3.0 Tailoring Your User Experience | 21