User guide

Figure 3-5 Defining IP Settings
Step 2
C
onfigure the IP addresses.
Step 3
Press Close to exit the quick setup wizard.
Configuring Gatekeeper Settings
If your SCOPIA XT Series works in conjunction with a gatekeeper, configure gatekeeper-related
settings. Use this section to configure gatekeeper settings.
This procedure completes the basic system configuration.
Before you begin
This procedure is performed as part of the basic configuration after “Configuring Network
Settings” on page 12.
Procedure
Step 1
Set the Enabled list to Yes.
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.0 Getting Started | 13