Installation guide

Procedure

Step 1

Select Administrator > Settings > Network > Preferences > Dynamic Ports.

Step 2

Modify the TCP base port in the Ports field.

Note

You can configure the base port to any value between 1024-65535. The number of

ports is calculated automatically by the system, depending on whether you have an

MCU license and its type.

Step 3

Select Save.

Configuring the UDP Port Range for RTP and RTCP on the SCOPIA XT Series

The SCOPIA XT Series has designated UDP ports 3230-3305 for RTP and RTCP. You can

configure the port range by setting the base port, which is the lower end of the port range (if,

for example, port 3230 is busy).

Procedure

Step 1

Access the SCOPIA XT Series web interface.

Step 2

Select the Administrator settings tab.

Step 3

Select Network in the left pane.

Step 4

Select Dynamic ports under Preferences.

Figure 6-1 Configuring UDP settings

Step 5

Modify the UDP base port in the Ports field.

RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Implementing Port Security for the SCOPIA XT Series | 84