Installation guide

To do this, the gatekeeper must register all endpoints to maintain the mapping list of aliases
and endpoints to successfully route calls. It also registers gateways to ensure that a call can
be routed to a non-H.323 entity, since gateways form the bridge from H.323 to other
protocols, such as ISDN.
When registering with a gatekeeper like SCOPIA ECS Gatekeeper, the endpoint sends its IP and
aliases. Registration occurs before any calls are attempted and may occur periodically, or
once, such as during endpoint power-up.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
Step 2
Select Administrator Settings.
Step 3
Select Protocols.
Step 4
Select General under H.323.
Figure 5-25 Configuring H.323 settings
Step 5
Set the fields as described in Table 5-18 on page 64.
Table 5-18 Configuring H.323 settings
Field Name Description
H.323 Name The H.323 name or ID (alias) used to register the unit with the
gatekeeper.
E.164 The E.164 number used to register the unit with the
gatekeeper.
Step 6
Select Save.
Step 7
Select Gatekeeper under H.323.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 64