Installation guide

Configuring Network Connectivity
If necessary you can configure the GLAN1 and GLAN2 ports. The GLAN2 port is available only if
it is enabled. For more information, refer to “Installing and Enabling Licenses which Extend
System Functionality” on page 27.
Carefully match these settings with the equivalent settings in the network and the remote
endpoints to avoid connectivity issues.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
Step 2
Select Administrator Settings.
Step 3
Select Networks.
Step 4
Select Parameters under GLAN.
Figure 5-21 Configuring the GLAN parameters
Step 5
Set the field as described in Table 5-14 on page 59.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 58