Installation guide

Figure 5-10 Configuring general camera settings
Step 3
Configure settings on the General page as described in Table 5-6 on page 41.
Table 5-6 Configuring general camera settings
Field Name Description
Default camera Specifies to which input of the XT Codec Unit the main camera
is connected. Typically it is HD CAM 1. The default camera is
automatically activated when the system powers up.
Driver Sets the camera driver for the connected camera.
Automatic setting allows automatic identification of the
correct driver at system start up. This feature is available only
if the camera is connected using a VISCA Cross cable.
Camera control by far site Enables/disable control of my camera(s) by the remote
endpoint.
Bring back to place If enabled, the system stores camera positions when the
camera is turned off.
Always power on camera Ensures the camera does not automatically power off,
enabling the system to be switched on via remote control, if
the camera has an infra-red receiver.
Camera privacy mode Places the camera in a sleep position, with the lens facing
down and to the left, when the system is in screen saver or
privacy mode.
Digital zoom Enables digital zoom for cameras equipped with this feature.
Step 4
Select Save.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 41