Installation guide

Figure 5-8 Setting the XT Remote Control Unit Code
Step 3
Enter the code in the Remote control code field.
Step 4
Select Save.
Step 5
On the XT Remote Control Unit, press
and simultaneously.
The On/Off key on the XT Remote Control Unit turns red.
Step 6
Using the keypad, type the number you just entered in the Remote control code field.
Note
You must always use two digits for a code. For example, to set the code to “1”,
enter “01”.
The code of the XT Remote Control Unit is changed and the Remote Control icon and the
new Remote Control code appear at the top of the screen.
Configuring the Screen Saver to Start Automatically
The screen saver helps to protect your monitor from burn-in without switching it off. This can
be useful in situations when you stop using your SCOPIA XT Series for a relatively short period
of time.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
Step 2
Select the User settings tab.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 39