Installation guide

Table 5-5 Configuring regional information
Field Name Description
System name Enter the name that will appear in the local endpoint GUI and in the
remote endpoint GUI (if connected).
Country Select the country in which the local system is located. Once the
country is selected, the other fields are populated automatically.
Language Select the language used in the GUI.
Audio coding Select the European or US coding.
Video frequency The video refresh frequency depends on the country, and may
assume the values of 50Hz or 60Hz. The user may select the video
frequency automatically or manually. If set to automatic, the system
assigns the value depending upon the selected country. In Japan, the
frequency depends on the country area (east or west); thus in Japan
the system administrator must select manually the correct value
related to the geographic location.
Step 5
Select Save.
Pairing a XT Remote Control Unit with a XT Codec Unit
Multiple XT Codec Units can be set up in the conference room and controlled with different XT
Remote Control Units.
You can dedicate your XT Remote Control Unit to monitor one or more XT Codec Units of your
choice by configuring the same numeric code in your XT Remote Control Unit and the system
software.
An XT Remote Control Unit is configured with code 01 by default.
Before you begin
Decide what numeric code you want to use for your monitor and the XT Codec Unit.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
Step 2
In the User settings tab, select User preferences > General > General.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 38