Installation guide

Table 5-4 Configuring time zone related settings

Field Name Description

Select the time zone to which the system belongs.

Enable daylight time Set the daylight or summer time field to Yes or No

according to the current daylight-saving status of your

time zone.

Start (dd/mm) Set the day and month to indicate when daylight

saving times start.

Stop (dd/mm) Set the day and month to indicate when daylight

saving times end.

Step 5

Select Save.

Step 6

Press F5 to refresh the login.

Setting Regional Information

You must configure the region-related settings: the country and language. You also need to

configure audio coding and video frequency, because your video network depends on the local

infrastructure. Notice the system suggests the optimal values for audio coding and video

frequency when you enter the country value.

You may have set some of these fields in the Quick Setup screens as they belong to the

minimal setting requirements. You can modify these settings at any time.

You can configure the regional information either using your SCOPIA XT Series interface or

remotely, using the XT Series web interface.

Procedure

Step 1

Access the SCOPIA XT Series web interface.

Step 2

Select Administrator Settings.

Step 3

Select System > Location > General on the left.

Step 4

Set settings as described in Table 5-5 on page 38.

RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 37