Installation guide

Before you begin
This procedure is performed as part of the basic configuration after “Configuring Network
Settings” on page 33.
Procedure
Step 1
Set the Enabled list to Yes.
Figure 5-6 XT Codec Unit
Step 2
Set the Mode list to Manual.
Step 3
Enter the IP address of the gatekeeper in the IP address field.
Step 4
Enter the H.323 number required to dial the XT Codec Unit in the Number H.323 field.
Step 5
Select Done.
The basic configuration of your SCOPIA XT Series is complete.
Setting the Administrator or User Password
You can set or change passwords for both user and administrator. The default password is
1234. We recommend that you change the administrator password when starting the system
configuration to prevent users from changing settings by mistake.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 34