Installation guide

Configuring Network Settings
This page allows you to setup the GLAN1 settings and the IP address the system uses for
placing a call.
Consult with your network administrator to configure these fields.
Before you begin
This procedure is performed as part of the basic configuration after “Adjusting the Image
Position” on page 31.
Procedure
Step 1
Press
and scroll to Yes from the Automatic IP address list.
Figure 5-5 Defining IP Settings
Step 2
Configure the IP addresses.
Step 3
Press Close to exit the quick setup wizard.
Configuring Gatekeeper Settings
If your SCOPIA XT Series works in conjunction with a gatekeeper, configure gatekeeper-related
settings. Use this section to configure gatekeeper settings.
This procedure completes the basic system configuration.
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 33