Installation guide

•
Adjusting the Image Position.............................................................. page 31
•
Configuring Network Settings............................................................. page 33
•
Configuring Gatekeeper Settings......................................................... page 33
The tasks appear in this section in the order they are presented in the quick setup wizard.
The quick setup wizard automatically appears when you turn the XT Codec Unit on for the
first time. If the quick setup wizard is not displayed automatically, select Configure on the
Main Menu page and then select Quick setup.
Setting the System Name and Language-related Settings
This page allows you to select the name of your XT Codec Unit. The name is displayed on the
monitors participating in the videoconference call (for example: Hong-Kong, or 9th-Floor-
Room, or NY-Office). You can also configure the fields required for setting up calls.
You can also select the country in which the system is located and the language in which the
system menus are displayed.
Before you begin
Turn on the SCOPIA XT Series unit to start the quick setup wizard.
or
If the quick setup wizard is not displayed automatically, in the Main menu page select
Configure > Quick Setup.
Procedure
Step 1
Enter the name of the SCOPIA XT Series in the System name field using the alphanumeric keys
of the XT Remote Control Unit.
By default you can enter letters before you can enter digits. To change the input method
press .
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 30