Installation guide

Figure 5-1 Enabling remote access to the SCOPIA XT Series
Step 3
Set the fields as required.
Table 5-2 Enabling remote upgrade
Field Name Description
Download management Enables/disables downloading of firmware or patches to the XT
Codec Unit.
Enable all addresses If set to Yes, enables access to the XT Codec Unit from any IP
address in a network. If set to No, configure Address and SubNet
mask.
Address Enter the IP address allowed to access the XT Codec Unit.
SubNet mask Enter the SubNet mask associated with the IP address.
Step 4
Press Save.
Performing Basic Configuration
During this configuration you define some basic settings for your SCOPIA XT Series, like user
interface language, the system name, and network settings. Notice that your system
administrator might already have set these parameters for you.
In addition to fresh installations, you need to use the quick setup wizard after restoring
default settings and re-installing software.
The quick setup wizard guides you through these basic configuration tasks:
•
Setting the System Name and Language-related Settings............................. page 30
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 29