Installation guide

Before beginning the installation of the system, you must read the safety regulations for a
safe use of the system, verify the conference room setup, and check that the product
corresponds to your order. The setup prerequisites are described in these sections:
•
Complying with Safety Regulations...................................................... page 10
•
Planning the Conference Room Setup................................................... page 10
•
Inspecting the Product..................................................................... page 11
Complying with Safety Regulations
For detailed safety information consult the SCOPIA XT Series Safety Instructions leaflet
enclosed in the delivery package.
Planning the Conference Room Setup
Set up the conference room to enjoy virtual meeting. RADVISION provides useful information
on conference room setup in http://blog.radvision.com/videooverenterprise/2010/05/11/ask-
the-expert-designing-your-conference-room/
SCOPIA XT Series can receive the Infra-Red (IR) command of the XT Remote Control Unit via:
•
The XT Codec Unit IR receiver
•
The IR receiver of the XT Standard II Camera. In this case the XT Remote Control Unit
sends the command to the XT Codec Unit using the VISCA connection. The position of the
XT Codec Unit in the conference room is not important for receiving the signal from the
XT Remote Control Unit. But it is important to connect the main camera correctly to the
XT Codec Unit via the VISCA Cross cable.
Place the XT Codec Unit anywhere within 5 meter reach of the camera cables. Leave enough
space for air circulation and for connecting cables easily.
3
Prerequisites for Setting up the System
RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Prerequisites for Setting up the System | 10