Installation guide

'Hardware Setup' | 19
RADVISION | Installation Guide for SCOPIA XT1000 Version 2.0
Procedure
Step 1 Connect the optional Standard Camera to the HDMI2 input of the Codec Unit. In this configuration,
it is possible to send HDMI1 or HDNMI2 as main stream video. As a second stream video it is
possible to send the signal present on the DVI input (usually a PC presentation). You can control
both cameras (HDMI1 and HDMI2) by using the XT1000 Remote Control Unit.
Figure 2-14 Connecting the Optional Standard Camera
Step 2
(Optional) Connect the optional camera to the Codec Unit’s DVI input (instead of connecting a
PC). In this configuration, it is possible to transmit simultaneously two streams coming from two
different cameras. You can control only the HDMI1 camera with the XT1000 Remote Control Unit.
To control the DVI camera, use the camera’s own remote controller.
Note: Do not connect the VISCA Cross cable in that configuration.
Step 3 (Only if using the XT1000 Remote Control Unit to control the camera.) Connect the VISCA Cross
cable between the Standard Camera and the optional camera.